Table of Contents
Advertisement
Function
The trigger is an event on the probe which causes the analyzer to
begin acquiring data and filling trace memory.
The trigger command can also position the trigger at the start,
center, or end of trace memory.
Default Values
The default is a "don't care" trigger positioned at the start of the
trace.
Parameters
and
anything
any_glitch
on
or_on
< BIT# >
< DELAY>
nsec_after,
usec_after,
msec_after
This option allows you to specify an
additional label or label bit to be added to
the conditions.
This option specifies the trigger to be any
signal change. The change can be qualified
with an edge condition.
This option specifies the trigger to be a
glitch. The glitch can be on any signal, or
qualified by label or label bit. This option is
available only in glitch capture mode.
You use this option to qualify the signals on
which a glitch may trigger the analyzer.
This option used to add additional signals to
the glitch condition qualifier.
This prompts you to enter bit number for the
pattern or edge.
This prompts you to enter a delay. The
analyzer waits the duration of the delay after
the trigger before beginning to sample the
signals.
These parameters specify the units of
measurement of < DELAY> in
Timing: Commands 9-87
Advertisement
Table of Contents
