Table of Contents
Advertisement
Parameters
always
when_marks_x_o
greater_than
less_than
< MARKS>
when_time_x_o
greater_than
less_than
< TIME>
nsec,
usec,
msec,
sec
This option resets this option to its default
condition.
This option specifies that only traces with a
number of marks between the mark_x and
mark_o points (inclusive) will be included in
the statistical sample.
This parameter specifies the mark count
must be greater than the number entered.
This parameter specifies the mark count
must be less than the number entered.
This prompts you to enter the number of
marks below or above which the trace will be
included in the sample.
This option specifies that only traces with a
specified time interval between the mark_x
and mark_o points will be included in the
statistical sample.
This parameter specifies the duration must
be more than the time entered.
This parameter specifies the duration must
be less than the time entered.
This prompts you to enter the time interval
below or above which the trace will be
include in the sample.
These parameters specify the units of
measurement of < TIME> in nanoseconds,
microseconds, milliseconds, or seconds,
respectively.
Timing: Commands 9-81
Advertisement
Table of Contents
