Table of Contents
Advertisement
Ending to Continue
Later
Ending and Blocking
other Access
Selecting the
Measurement System
or Another Module
In order to use the system again, you must reinitialize the analyzer
configuration.
You can continue later without effecting other users by simply
using the command
end <RETURN>
which ends the current session, but preserves the configuration
status. Other users are not effected.
You can also end a session with the intention to continue later and
block other users access to the analyzer by using the command
end locked <RETURN>
which ends the current session, preserves the configuration status,
and ends other users sessions. You can then reexecute the Timing
Analysis Softkey Interface later, assuring that you return to the
system as you left it.
In the pmon or MEAS_SYS environment, if you have configured
the system with more than one measurement system, you can select
one of the other measurement systems when ending the Timing
Analysis interface.
Timing: Using the Analyzer 8-33
Advertisement
Table of Contents
