Table of Contents
Advertisement
You return to the HP-UX shell or PMON depending on how you
entered emulation. Unless you choose "end release_system", the
current emulation configuration is stored so that on reentry to the
emulation module, you can resume the emulation session.
Note
Entering < CTRL> -D performs the same operation as entering
"end < RETURN> ".
Entering < CTRL> -\ or < CTRL> -| (in other words, sending
SIGQUIT to the user interface process) is the same as entering
"end release_system < RETURN> ".
Default Values
When the analyzer session is ended, control is returned to the
environment (HP-UX or PMON) you were in when the Softkey
Interface was entered without releasing the analyzer. The analyzer
is locked to the current user so that the session may be continued
later. Other instances of the user interface are not affected.
Parameters
locked
release_system
This option closes all active instances of the
user interface in any combination of
windows and terminals. Each closed
instance will return to the environment in
which the Softkey Interface was entered.
Thus, "end locked" is the same as entering
"end" at all of the instances. The
configuration of the ending instance
becomes the configuration used when you
start the analyzer later. This option is not
available when operating the analyzer in the
measurement system.
This option closes all active instances of the
user interface in any combination of
windows and terminals. Each closed
instance will return to the environment in
Timing: Commands 9-29
Advertisement
Table of Contents
