C onfiguring
1
Interactive
Measurements
5-14 Using the External Analyzer
First external label polarity?
This configuration question allows you to specify positive or
negative logic for the external bits. In other words, positive means
high= 1, low= 0. Negative means low= 1, high= 0.
Define second external label?
Allows you to define additional labels. Up to eight external labels
can be defined.
When using the "state" or "timing" options for the external analyzer
mode, you can configure the analyzer to trigger the external
analyzer. This ensures that traces are returned only when the
analyzer is running.
To configure the analyzer for interactive measurements, enter
modify configuration
in the emulator Softkey Interface.
Now, press the < RETURN> key until you see the question:
Modify Interactive Measurement Specification?
Answer the prompt "yes" by pressing the yes softkey, or entering
"yes" at the command line. You then see a display as depicted in
figure 5-9.
<RETURN>