Table of Contents
Advertisement
mode. You need to correct the trigger specification or change
modes.
ERROR: New label already exists
This message appears when trying to rename a format specification
label to a new name. The new name already exits and cannot be
reused without removing the existing name. The existing name can
itself be renamed or deleted.
ERROR: " or_on" is not possible, all bits are already specified
This message is displayed when you try to enter a trigger
specification which uses bits which have already been specified.
You need to correct the specification.
ERROR: Pattern not found
This message indicates a find command could not locate the
specified pattern and condition in the segment of memory
searched. You can try broadening the search conditions.
ERROR: Permission denied
This message indicates the read or write permissions inhibit the
analyzer from reading or modifying the specified file. You correct
the permissions or use a different file.
ERROR: Process_for_data definition is invalid
This message appears when you change mode or redefine the labels
in such a way that the "process_for_data" definition is no longer
valid. You need to correct the "process_for_data" definition.
ERROR: Range must be greater than one sample
This message appears when you try to find an event and the range
you specify is only one sample wide. You need to expand the search
range specification.
ERROR: Sample exceeds memory depth
This message appears when you enter a "process_for_data"
command with a number of samples "before" or "after" a transition
and the number of samples is greater than the memory depth of the
analyzer. You need to correct the "process_for_data" condition.
Timing Messages C-9
Advertisement
Table of Contents
