Adding And Removing Snmp V3 Users - Symmetricom TimeProvider 5000 User Manual

Chapter 4 Provisioning
Provisioning for SNMP
To add a v2 community named "tech27", with a security level of "read-only" and
remove an existing v2 community named "bob321":
1. Type
set snmp add v2-community tech27 securlvl read-only
Enter.
2. Type
set snmp delete v2-community bob321

Adding and Removing SNMP v3 Users

SNMPv3 provides additional security features not available in SNMPv2c. In addition
to the functions of SNMPv2c, SNMPv3 allows user and trapuser levels that are
based on authentication and privacy settings. The authentication algorithm is either
HMAC-SHA-1-96 or MD5, with a key up to 32 characters in length. The privacy
settings are based on either the CBC-DES or AES encryption standard, with a with
a key up to 32 characters in length. All keys are uppercase.
Use the "set snmp add user" command to add a v3 user. Use the "set snmp delete
user" command to remove an existing v3 user. The TP5000 will support a maximum
of 10 v3 users.
Example - Add User
To add a user named "test12", with a security level of "priv", with a 20-character
MD5 authentication key "123456789ABCDEFGHIJK" and a 16-character DES
privacy key "ABCDEFG123456789":
1. Type
set snmp add user test12 securlvl priv
2. Enter
MD5
3. Enter
123456789ABCDEFGHIJK
4. Enter
DES
5. Enter
ABCDEFG123456789
Note:
Only characters {a-z,A-Z,0-9,! ( ) - _ . ? ~ * @ ^ + = : / %} are
accepted for SNMP authentication or privacy keys.
Example - Remove User
312 TimeProvider 5000 User's Guide
at the authentication protocol prompt.
at the authentication key prompt
at the privacy protocol prompt
at the privacy key prompt
Do not use spaces within keys.
then press
then press Enter
then press Enter.
098-00028-003 Revision A – June, 2011