Symmetricom TimeProvider 5000 User Manual page 188

Chapter 3
TimeProvider 5000 CLI Command Set
show ptp-config
Use these commands to display the PTP port's common provisioned attributes,
multicast-specific attributes, and unicast-specific attributes.
Common Provisioned Attributes:
PTP Address Mode, Management Address Mode, TTL, Alternate Master, Clock ID,
PTP state, two-step, priority1, priority2, domain, DiffServ code point, maximum
number of clients, sync limit, announce limit, delay limit, unicast negotiation, unicast
lease interval, dither
Multicast Specific Attributes:
Announce Message Timeout, Client Timeout, VLAN ID, Sync Message Interval,
Announce Message Interval, Delay Message Interval
Unicast-Static Specific Attributes:
Unicast IP addresses, VLAN ID, Sync Message Interval, Announce Message
Interval, Delay Interval, Clock ID
Command Syntax:
To display the specified PTP port's common provisioned attributes:

show ptp-config common { ioc1-1 | ioc1-2 | exp[0-9] port
<1-16>}
To display the specified PTP port's multicast provisioned attributes:

show ptp-config multicast { ioc1-1 | ioc1-2 | exp[0-9] port
<1-16>}
To display the specified PTP port's unicast-static provisioned attributes:

show ptp-config unicast {ioc1-1 | ioc1-2} index [1-10]
where
Example 1:
To show the PTP Common mode configuration for Port 1 on the active IOC 
tp5000> show ptp-config common ioc1-1
Response 1:
188 TimeProvider 5000 User's Guide
index= client number
098-00028-003 Revision A – June, 2011