Set Ip-Mode Command - Symmetricom TimeProvider 5000 User Manual

Figure 4-1.

Set IP-Mode Command

Example
1. Login at the Admin or Config-user level (see
2. Type
set ip-mode imc dhcp
3. Type
set ip imc restart
Static IP Mode
Use the following procedure to configure the TimeProvider 5000 IP parameters
(Host Address, Subnet Mask, and Gateway Address) in Static IP mode on the
MGMT port. Use the dot-decimal notation format xxx.xxx.xxx.xxx to enter the
address parameter. See
Example
1. Login at the Admin or Config-user level (see
2. Type
set ip-mode imc static
3. Type
set ip imc address 192.168.0.10 netmask 255.255.255.0 gateway
192.168.0.1
4. Type
set ip imc restart
098-00028-003 Revision A – June, 2011
and press Enter.
and press Enter.
Figure 4-2.
and press Enter.
and press Enter.
.
Chapter 4 Provisioning
Provisioning the Ethernet Ports
Logging In, on page 235).
Logging In, on page 235).
TimeProvider 5000 User's Guide 241