Symmetricom TimeProvider 5000 User Manual page 110

Chapter 3
TimeProvider 5000 CLI Command Set
set gps
Use this command to provision the GPS port for mode of operation, position, and
positioning elevation mask. With this command, you can provision the GPS to use
either automatic or manual mode to determine the system's position. You can
provision the GPS position if the system is provisioned for Manual mode of
operation. You can also provision the elevation mask to provide a method of filtering
satellites to be used by the system.
Note: Latitude and Longitude are entered as pddd:mm:ss.sss, where
p is N or S for latitude and E or W for longitude, ddd is degrees, mm is
minutes, and ss.sss is seconds. For example: N59:20:3.458 or
W121:31:42.69. Height is in meters, with a range of -999.9 to 40000.0
meters
Command Syntax:
To set the GPS mode

set gps mode {auto|manual} [latitude <lat-value> longitude
<lon-value> height<height-value>]
– Position can only be provisioned manually when GPS mode is "manual".
Where
Note: Symmetricom recommends that the Auto mode be used. Any
error in the manually-specified system position will generate timing
errors.
To enable or disable GPS

set gps state {enable|disable}
To set the GPS priority

set gps priority <priority-value>
110 TimeProvider 5000 User's Guide
Latitude is in the format N|Sddd:mm:ss.sss, for example:
N37:22:45.123
S48:33:67.456
Longitude is in the format E|Wddd:mm:ss.sss, for example:
W121:55:36.123
E157:33:47.456
Height is in meters with one digit after the decimal point, for
example:
17.5
098-00028-003 Revision A – June, 2011