Symmetricom TimeProvider 5000 User Manual page 228

Chapter 3
TimeProvider 5000 CLI Command Set
set vlan-config expansion exp[0-9] port <1-16> vlan-id <id>
priority <priority-value> {layer2 | address <IP> netmask
<mask> gateway <gway>}
Use
set ip <port> restart
Note: Each VLAN must be configured on a separate subnet.
Range: Index = 1 thru 16 (for VLAN table index)
vlan-id = 1 thru 4094
priority = 0 thru 7
Default: No VLAN configured
Example 1:
To Enable the VLAN on port 1 of IOC1-1 
tp5000> set vlan-mode ioc1-1 enable
Note: In order to Enable the VLAN mode for a port, at least one
Index must be already be configured and Enabled on the VLAN for
that port. See the set vlan-config state
Example 2:
To add a VLAN on IOC1-1 with VLAN ID = 25, Index=3, Priority=0, where the IP
address= 192.168.1.5 Netmask=255.255.255.0, and Gateway=192.168.1.1 
tp5000> set vlan-config add ioc1-1 index 3 vlan-id 25
priority 0 address 192.168.1.5 netmask 255.255.255.0 gateway
192.168.1.1
Example 3:
To modify Index 3 on an existing VLAN on IOC1-1 with the new IP address of
192.168.1.7, Netmask=255.255.255.0, and Gateway=192.168.1.1 
tp5000> set vlan-config modify ioc1-1 index 3 address
192.168.1.7 netmask 255.255.255.0 gateway 192.168.1.1
Example 4:
To Delete the VLAN configuration for Index 4 on port 1 of IOC1 
tp5000> set vlan-config delete ioc1-1 index 4
Example 5:
228 TimeProvider 5000 User's Guide
after configuring VLAN to apply changes.
command
.
098-00028-003 Revision A – June, 2011