Symmetricom TimeProvider 5000 User Manual page 182

Chapter 3
TimeProvider 5000 CLI Command Set
To set the timescale for IOC1 to PTP:
tp5000> set ptp timescale ioc1 ptp

Example 5
To Enable the alternate master mode for IOC1:
tp5000> set ptp alternative-master ioc1 enable
Note: If the Alternate Master mode is set to Enable, the alternate
master flag will be set in the PTP messages.

Example 6
To Enable port 1 of IOC1 for PTP:
tp5000> set ptp state ioc1-1 enable

Example 7
To set the IP Header Time to Live (TTL) for IOC1 to a value of 6:
tp5000> set ptp ttl ioc1-1 6

Example 8
To set the maximum number of clients to "100" for port 1 of IOC1:
tp5000> set ptp max-client ioc1-1 100

Example 9
To set the PTP announce limit to no less than 0.5 seconds (2
tp5000> set ptp announce-limit ioc1-1 -1

Example 10
To set the PTP sync limit to no less than 0.125 seconds (2
tp5000> set ptp sync-limit ioc1-2 -3

Example 11
To set the PTP delay limit to no less than 0.250 seconds (2
tp5000> set ptp delay-limit ioc1-1 -2

Example 12
182 TimeProvider 5000 User's Guide
Common Attributes:
Common Attributes:
Common Attributes:
Common Attributes:
Common Attributes:
Common Attributes:
Common Attributes:
Common Attributes:
-1
) for port 1:
-3
) for port 2:
-2
) for port 1:
098-00028-003 Revision A – June, 2011