Provisioning Output Generation Behavior - Symmetricom TimeProvider 5000 User Manual

3. Type
set output frametype port1 freq1544khz
4. Type
set output ssm port1 disable
5. Type
set output state port1 enable
D4 Frame Type
To provision Port 2 as an output port with a frametype of D4, SSM disabled, and to
enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port2 output
3. Type
set output frametype port2 d4
4. Type
set output ssm port2 disable
5. Type
set output state port2 enable
ESF Frame Type
To provision Port 2 as an output port with a frametype of ESF, SSM enabled,
SSM-bit of 6, and to enable the port:
1. Login at the Admin or Config-user level.
2. Type
set io port2 output
3. Type
set output frametype port2 esf
4. Type
set output ssm port2 enable
5. Type
set output ssm-bit port2 6
6. Type
set output state port2 enable

Provisioning Output Generation Behavior

The behavior of the output ports during warm-up, free-run, and holdover states can
be provisioned using the "set output warm-up", "set output free-run", and "set output
holdover" commands, as shown in
098-00028-003 Revision A – June, 2011
Provisioning the Programmable E1/T1 Outputs
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
Figure 4-20.
Chapter 4 Provisioning
and press Enter.
TimeProvider 5000 User's Guide 277