Upgrading The Imc - Symmetricom TimeProvider 5000 User Manual

Example - SFTP: For an SFTP server with IP address 192.168.5.65, a user
name of "user1", and a upgrade file path of "/ver2.bin" the command is:
upgrade ioc1 /ver2.bin 192.168.5.65 user1
4. When prompted, enter the password for the server. The new software is loaded
into the IOC.
Note: The system will transfer the file from the specified server and
then upgrade the module.
The TimeProvider 5000 validates the received file. It updates the flash memory
only if the file is valid.
5. Type
reboot ioc1
Warm-up mode for up to 30 minutes.

Upgrading the IMC

To upgrade the software in the IMC, use the following procedure:
Note:
procedure.
1. Login at the Admin level (see
2. Type
set configuration backup local
of the IMC configuration.
3. Type
upgrade imc <filepath> <ftp-server> <user name>
address of the FTP server) and press Enter.
Note: The FTP firewall is set to "Block" by default. Use the following
command to set the IMC firewall to "Allow" for telnet communications:
Note: The TimeProvider 5000 only supports active FTP; it does not
support passive (PASV) mode.
098-00028-003 Revision A – June, 2011
to reboot the IOC. After the IOC reboots it enters the
Outputs are not affected during the IMC upgrade
Logging In And
set firewall imc ftp allow
Chapter 6 Maintenance and Troubleshooting
Upgrading the Firmware
Out, on page 316).
and press Enter to save the contents
(use the IP
TimeProvider 5000 User's Guide 347