Verify Expansion Configuration - Symmetricom TimeProvider 5000 User Manual

Verify Expansion Configuration

Symmetricom recommends that users verify the configuration of the DTI / ETH ports
before provisioning.
1. Login at the Admin, Config, or User level.
2. Type
show exp-if config imc
3. Type
show exp-if config io
4. Type
show exp-if config exp0
Provisioning DTI / Ethernet Port on IMC Card
To Enable
To enable DTI and Ethernet on the IMC module, use the following procedure.
1. Login at the Admin or Config-user level.
2. Type
set exp-if eth imc-exp state enable
3. Type
set exp-if dti imc-exp enable
To Disable
If there are no expansion shelves being used with the TP5000, Symmetricom
recommends that the Ethernet port of the exp-if interface be disabled. The DTI port
of this interface can also be disabled, however, it is not necessary to do so. Use the
following procedure to disable the Ethernet and DTI ports of the exp-if interface on
the IMC card.
1. Login at the Admin or Config-user level.
2. Type
set exp-if eth imc-exp state disable
3. Type
set exp-if dti imc-exp disable
Provisioning DTI Ports on IO Card
1. Login at the Admin or Config-user level.
2. Type
set exp-if dti io-exp-1 enable
3. Type
set exp-if dti io-exp-2 enable
098-00028-003 Revision A – June, 2011
Provisioning TP 5000 for Expansion Shelf
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
and press Enter.
TimeProvider 5000 User's Guide 283
Chapter 4 Provisioning