Adding And Removing Snmp V3 Trap Users - Symmetricom TimeProvider 5000 User Manual

Chapter 4 Provisioning
Provisioning for SNMP
5. Enter
ABCDEFG123456789
Note:
Only characters {a-z,A-Z,0-9,! ( ) - _ . ? ~ * @ ^ + = : / %} are
accepted for SNMP authentication or privacy keys.
Example - Remove User
To remove an existing user named "dave123":
1. Type
set snmp delete user dave123

Adding and Removing SNMP v3 Trap Users

Use the "set snmp add user" command to add a v3 trap user. Use the "set snmp
delete trapuser" command to remove an existing v3 trap user. The TP5000 will
support a maximum of 3 v3 trap users.
Note:
be added as a user. The same name, authentication protocol,
authentication key, privacy protocol, and privacy key must be
used for both the user and trap user.
Example - Add Trap User
To add a trap user named "test12" with a security level of "priv", with the
20-character MD5 authentication key "123456789ABCDEFGHIJK" and
16-character DES privacy key "ABCDEFG123456789":
1. Type
set snmp add trapuser test12 securlvl priv
2. Enter
MD5
3. Enter
123456789ABCDEFGHIJK
4. Enter
DES
5. Enter
ABCDEFG123456789
Example - Remove Trap User
To remove an existing trapuser named "dave123":
1. Type
set snmp delete trapuser dave123
358 TimeProvider 5000 User's Guide
at the privacy key prompt
Do not use spaces within keys.
In order to access trap information, a trap user must also
at the authentication protocol prompt.
at the authentication key prompt
at the privacy protocol prompt
at the privacy key prompt
then press Enter
then press Enter.
then press Enter
098-00028-000 Revision F – May, 2012