Symmetricom TimeProvider 5000 User Manual page 175

set ptp addr-mode ioc1-[y] {unicast | multicast |
multicast-hybrid}
where
Note: In Multicast-Hybrid address mode, the TP5000 sends sync and
announce messages using Multicast, but delay response messages
are Unicast.
To provision the management addressing mode as Multicast or Unicast:

set ptp mgmt-addr-mode ioc1-[y] {unicast | multicast}
Note: Management addressing mode controls whether PTP
management messages use Multicast or Unicast. This is independent
of the set ptp addr-mode command. For example, management
addressing can be set for Multicast while PTP synchronization is
using Unicast. For multicast management, the client must be in the
TP5000's client list.
To provision the state of the Two-Step Clock mode:

set ptp two-step {ioc1-1 | ioc1-2 | exp[0-9]} {enable |
disable}
– If the Two-Step Clock state is Disable, a One-Step Clock is used.
To provision the timescale for IOC1 or expansion shelf 1 -10 (id= exp0 - exp9) to

Automatic, Arbitrary or PTP:
set ptp timescale {ioc1 | exp[0-9]} {auto| arb | ptp}
– If the timescale is set to "auto", the TP5000 will make the decision based
on the input. The TP5000 will set the timescale to "ptp" if the unit is locked
to gps. The TP5000 will set the timescale to "arb" if the unit is locked to
any other reference besides gps (i.e. E1 and T1).
To provision the Alternate Master mode:

set ptp alternative-master {ioc1-1 | ioc1-2 | exp[0-9]}
{enable | disable}
Note: If the Alternate Master mode is set to Enable, the alternate
master flag will be set in the PTP messages.
To provision the state for the specified PTP port on the IOC card or expansion

shelf:
set ptp state {ioc1-1 | ioc1-2 | exp[0-9]} {enable | disable}
To provision the IP Header Time to Live (TTL) field for PTP packets:

098-00028-003 Revision A – June, 2011
y= 1|2, the port number
Chapter 3
TimeProvider 5000 CLI Command Set
TimeProvider 5000 User's Guide 175