Symmetricom TimeProvider 5000 User Manual page 201

show redundancy
This command displays the IOC redundancy configuration: Port Bonding and IOC
Module.
Command Syntax:
To display the port redundancy configuration for the specified IOC module:

show redundancy port ioc1
To display the redundancy port status:

show redundancy active-port
Example 1:
tp5000> show redundancy port ioc1
Response 1:
Port redundancy : enabled
Example 2:
tp5000> show redundancy active-port
Response 2:
IOC active port: eth1
Response 2a:
If redundancy is disabled, the response to this command is:
IOC active port
Level : User, Config, and Admin
set redundancy
Use this command to provision the redundancy configuration for the Ethernet ports
on the IOC module.
Command Syntax:
set redundancy port ioc1 {enable|disable}
set redundancy active-port ioc-[y]
where
098-00028-003 Revision A – June, 2011
: no active port, redundancy disabled
Chapter 3
TimeProvider 5000 CLI Command Set
TimeProvider 5000 User's Guide 201