Symmetricom TimeProvider 5000 User Manual page 212

Chapter 3
TimeProvider 5000 CLI Command Set
show status
Use this command to display the following system status information:
Assigned System Name

Warm-up Status

– Current Stage
– Number of Stages
– Time in Current Stage While in Warmup
Uptime For The IMC

System Date And Time

Number Of Standing System Alarms

Uptime for each IOC

State of each IOC

Currently Selected ToD Source

Reference Input

Servo Control Status For The Active IOC Module

PTP Service Mode: GrandMaster or Probe

PTP Address Mode: Multicast or Unicast

Phase Offset Value (Valid in fast-lock and normal states, for GPS mode)

Command Syntax:
show status
Example 1:
To show status for the main shelf 
tp5000> show status
Response 1:
System name
IMC time
IMC uptime
IOC1 warmup status
IOC1 state
IOC1 uptime
IOC2 warmup status
IOC2 state
IOC2 uptime
212 TimeProvider 5000 User's Guide
: TP5000
: 2010-03-08 20:33:30
: 7 days 2 hrs 18 mins
: complete (total 1651 secs)
: active
: 7 days 2 hrs 18 mins
: n/a
: card not present
: card not present
098-00028-003 Revision A – June, 2011