Trigger Brake Lever Replacement; Non-Telemetry Led (Telemetry Off Sign); Handling The Antenna - FUTABA T10PX Short Manual

Trigger Brake Lever Replacement

The trigger brake lever can be replaced with the optional trigger brake lever for
7PXR / 7PX / 4PM.
*When the brake lever is changed, perform throttle side correction by adjuster function.
Brake lever replacement
1
Hold the trigger, remove the brake lever mount-
ing screw using the hex wrench, and remove the
brake lever.
2
Using the hex wrench install the brake lever with
the brake lever mounting screw.

Non-Telemetry LED (telemetry OFF sign)

When the telemetry function is inhibited by
race regulations, a special LED lights when
the telemetry function is OFF to confirm that
the telemetry function is not operating.
About The Transmitter Antenna
Cannot rotate more than 90˚.If rotated
forcibly, the antenna will be damaged.
Antenna
Caution
Please do not grasp the transmitter's antenna while driving.
Doing so may degrade the quality of the RF transmission to the model.
The antenna position can be changed in the direction as shown in figure. However, please do not ap-
ply unnecessary force or shock.
The internal cable may be damaged; thus transmitting distance decreases and it may cause malfunction.
There might be a small glitch when the antenna of the transmitter is brought close to servos, ESCs
or other peripheral devices.
This is not an issue but please keep this symptom in mind, especially when setting-up.
Non-telemetry LED
(Lit when telemetry function is OFF)

Handling The Antenna

Antenna Moving Range
If the antenna is set to the 45˚
and 90˚ vertical position, the
range of the radio waves may
be greater than in the horizon-
tal position. (Different depend-
ing on the conditions)
29
M2×6
Antenna