Alcatel-Lucent 5620 Troubleshooting Manual page 53

13
14
15
Figure 3-8 LAG member underlying port state in Properties form
16
Alcatel-Lucent 5620 Service Aware Manager, Release 6.1 R3
3HE 04244 AAAB Ed. 01
Find the object type that is lowest in the network object hierarchy, as listed in
Table 3-1. The lowest level object is a LAG.
Open the equipment view of the navigation tree. It indicates that there are alarms
related to both existing LAGs (Site Id 10.1.200.52 and Site Id 10.1.200.53).
However, there is no LAG alarm in the dynamic alarm list and the LAG State is Up.
Check states of related, supporting objects for the lowest-level object in the
alarm. Underlying port states may propagate alarms higher up the managed object
hierarchy without causing alarms on ports, LAGs, interfaces, protocols, and
sessions.
i In the equipment view of the navigation tree, choose a port under the LAG
on Router 53 (Site 10.1.200.53) and choose Properties from the contextual
menu. The LAG member properties form opens.
ii Click on the Port tab button to view the underlying port state of the LAG
member, as shown in Figure 3-8. The LAG Member 1/1/2 properties form
shows the Underlying Port State: Shut Down.
iii Repeat step 15 ii for the second port. The LAG Member 1/1/3 properties form
shows the State: Up.
In the equipment view of the navigation tree, choose port 1/1/2 under the Shelf
object that supports LAG 1 (Site 10.1.200.53), and choose Properties from the
contextual menu. The properties form opens, as shown in Figure 3-9.
Troubleshooting Guide
3 — Troubleshooting network alarms
November 2008 3-15