Alcatel-Lucent 5620 Troubleshooting Manual page 188

6 — 5620 SAM LogViewer
8
6-18
LogViewer enters display mode. Log updates are displayed as they occur.
To add a filter that restricts the types of log entries that are displayed during the
current LogViewer session, perform the following steps.
Press ↵ to enter command mode.
i
ii Enter the following at the prompt to return to the root menu:
root ↵
The following prompt is displayed:
log>
iii Enter the following at the prompt:
filter ↵
The following prompt is displayed:
log-filter>
Note — You can also use commands at this menu level to list and
delete filters.
iv Enter the following at the prompt:
add ↵
The following prompt is displayed:
Filter name:
Enter a name for the filter and press ↵.
v
vi The following prompts are displayed in sequence:
Level:
Logger:
Thread:
Timestamp:
Message:
At each prompt, enter a regular expression to use as a match criterion, if
required, and press ↵.
vii The following prompt is displayed:
Display Filter? (Y/N):
November 2008 Alcatel-Lucent 5620 Service Aware Manager, Release 6.1 R3
Troubleshooting Guide 3HE 04244 AAAB Ed. 01