Table of Contents
Advertisement
Table 40 Network Setting > QoS > Shaper Setup (continued)
LABEL
Outgoing
Interface
Rate Limit
(kbps)
Modify
10.6.1 Add/Edit a QoS Shaper
Click Add New Shaper in the Shaper Setup screen or the Edit icon next to a shaper to show the
following screen.
Figure 64 Shaper Setup: Add/Edit
The following table describes the labels in this screen.
Table 41 Shaper Setup: Add/Edit
LABEL
Active
Interface
Rate Limit
OK
Cancel
10.7 The QoS Policer Setup Screen
Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic
and apply actions, such as drop, pass, or modify the DSCP value for matched traffic. Click Network
Setting > QoS > Policer Setup. The screen appears as shown.
Chapter 10 Quality of Service (QoS)
DESCRIPTION
This shows the name of the GPON Device's interface through which traffic in this shaper
applies.
This shows the average rate limit of traffic bursts for this shaper.
Click the Edit icon to edit the shaper.
Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by
one when you take this action.
DESCRIPTION
Select to enable or disable this shaper.
Select the GPON Device's interface through which traffic in this shaper applies
Enter the average rate limit of traffic bursts for this shaper.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
PMG5317-T20A User's Guide
143
Advertisement
Table of Contents
