SCARABEO 500
• Unscrew and remove the screw fixing the speed
sensor and collect the nut.
•
Loosen the two screws fixing the fork
stem.
•
Remove the upper retainer «2».
•
Remove the wheel holder stem «3» by
pulling it from the below.
Overhaul
Wheel holder stem
•
Check the sliding surface for scorings and/or scratches. These scorings can be eliminated
by rubbing them with wet sandpaper (grain 1).
•
If the scorings are deep, replace the stem.
•
Use a dial gauge to check that the stem bending is below the limit value.
•
If over the value, replace the stem.
CAUTION
A BENT STEM SHOULD NEVER BE STRAIGHTENED BECAUSE ITS STRUCTURE WOULD BE
WEAKENED AND USING THE VEHICLE MAY BECOME DANGEROUS.
Characteristic
Suspensions
SUSP - 271