Injection
With the interface wiring disconnected from the
control unit, check continuity between pin 13 and
the Red cable of the rpm sensor connector and
between pin 15 and the White cable of the rpm
sensor connector.
With the interface wiring disconnected from the
control unit and the rpm sensor connector also
disconnected, check that the Red and White ca-
bles (pin 13 - 15) are insulated from each other and
insulated from the ground connection.
Specific tooling
020481Y Adaptor cable harness
020331Y Digital multimeter
HT coil
1
Injection electronic control unit
INJEC - 252
INJECTION LOAD
Specification
SCARABEO 500
Desc./Quantity