APRILIA SCARABEO 500 2008 Service Station Manual page 128

Engine
NOTE
BE CAREFUL NOT TO DAMAGE THE SHEATH OR THE BUSHING THREADED END.
- Finger tighten the ring nut and complete the tight-
ening to the prescribed torque using the appropri-
ate spanner.
Specific tooling
AP8140259 Tool for fitting/removing the clutch
on the driven pulley
Locking torques (N*m)
Clutch ring nut 65 - 75
- To facilitate refitting the clutch on the engine, turn the movable driven pulley and insert the belt into
the smaller diameter.
Refitting the driven pulley
- Fit the driven pulley unit together with the belt.
Drive-belt
- Make sure that the driving belt is not damaged.
- Check belt for correct width.
Characteristic
Minimum width
27.5 mm
Maximum width
28.7 mm
ENG - 128
SCARABEO 500