APRILIA SCARABEO 500 2008 Service Station Manual page 141

SCARABEO 500
Engine
- Heat the crankcase with an air heater.
Specific tooling
020151Y Air heater
020150Y Air heater support
- Using the specific tool fit the driven pulley shaft
bearing until it stops against the bottom of the seat.
NOTE
PLACE IT WITH THE BALLS FACING THE HUB
SIDE (THIS APPLIES TO BEARINGS WITH
PLASTIC CAGE).
Specific tooling
020376Y Adaptor handle
020360Y 52 x 55 mm adaptor
020364Y 25-mm guide
- Heat the intermediate gear bearing seat.
- Fit the intermediate shaft bearing using the spe-
cific tool.
NOTE
PLACE IT WITH THE BALLS FACING THE HUB
SIDE (THIS APPLIES TO BEARINGS WITH
PLASTIC CAGE).
Specific tooling
020376Y Adaptor handle
020359Y 42 x 47 mm adaptor
020363Y 20-mm Oil seal guide
- Heat the seat of the wheel axle bearing on the
crankcase.
- Fit the wheel axle bearing in the upper crankcase
seat using the specific tool.
NOTE
PLACE IT WITH THE BALLS FACING THE HUB
SIDE (THIS APPLIES TO BEARINGS WITH
PLASTIC CAGE).
Specific tooling
020376Y Adaptor handle
ENG - 141