APRILIA SCARABEO 500 2008 Service Station Manual page 140

Engine
- Heat the intermediate gear bearing seat.
- Fit the intermediate shaft bearing using the spe-
cific tool.
NOTE
PLACE IT WITH THE BALLS FACING THE HUB
SIDE (THIS APPLIES TO BEARINGS WITH
PLASTIC CAGE).
Specific tooling
020376Y Adaptor handle
020359Y 42 x 47 mm adaptor
020363Y 20-mm Oil seal guide
- Heat the seat of the wheel axle bearing on the
crankcase.
- Fit the wheel axle bearing in the upper crankcase
seat using the specific tool.
NOTE
PLACE IT WITH THE BALLS FACING THE HUB
SIDE (THIS APPLIES TO BEARINGS WITH
PLASTIC CAGE).
Specific tooling
020376Y Adaptor handle
020359Y 42 x 47 mm adaptor
020412Y 15-mm guide
- Place the safety Seeger ring locking the driven
pulley shaft bearing.
NOTE
PLACE IT IN THE POSITION SHOWN IN THE
FIGURE.
- Fit the pulley shaft oil seal on the transmission
side.
ENG - 140
SCARABEO 500