APRILIA SCARABEO 500 2008 Service Station Manual page 120

Engine
Air duct filter
- Remove the external air deflector.
- Undo the 2 fixing screws indicated in the figure
to remove the deflector filter.
Removing the driven pulley shaft bearing
- Remove the transmission cover.
- Remove the Seeger ring.
- Place the transmission cover on a wooden sur-
face and use the specific tool so that it is ade-
quately supported.
- Extract the bearing with the specific tool.
NOTE
BELL MUST BE PLACED INTO THE TRANS-
MISSION COVER, CLOSE TO THE BEARING
SEAT AND THE WOODEN SURFACE, SINCE
WITHOUT BELL THE ENTIRE COVER STRUC-
TURE WOULD BEND; NOT ONLY IN THE AREA
OF MAXIMUM STURDINESS.
Specific tooling
001467Y002 Driver for bearing with OD 73 mm
020376Y Adaptor handle
020375Y 28 x30 mm Punch
020439Y 17-mm guide for oil seal
ENG - 120
SCARABEO 500