APRILIA SCARABEO 500 2008 Service Station Manual page 211

SCARABEO 500
- Before installing the gear on the crankshaft, thor-
oughly clean both coupling surfaces and remove
any residues of LOCTITE left in the holes using a
brush.
Blow with compressed air and degrease the mounting holes on both surfaces to facilitate adherence of
the new LOCTITE applied.
Apply the recommended product on the holes again.
Recommended products
Loctite 243 Medium strength threadlock
-
- Repeat the same procedure for the 4 fixing screws.
- Insert the control gear on the crankshaft with the bore countersink visible.
- Tighten the 4 fixing screws to the prescribed torque.
NOTE
TO AVOID DAMAGING THE SCREW CONTROL HEXAGON, IT IS PREFERABLE TO USE AN IN-
SIDE HEXAGON BOX-SPANNER.
Locking torques (N*m)
Gear on crankshaft screws 10 -12
- Lubricate the main bearing on the flywheel-side
crankcase half.
- Lubricate the shim washer.
- Insert the shim washer on the crankshaft in its
original position.
- Insert the special timing tool in the hole on the
countershaft.
Specific tooling
020471Y Pin for countershaft timing
Engine
ENG - 211