APRILIA SCARABEO 500 2008 Service Station Manual page 133

SCARABEO 500
- Turn the pulley central nut so that the pulley holes
are aligned horizontally to fit the specific tool.
NOTE
CHECK THAT THE LOCK WRENCH TOOL CAN
BE EASILY FITTED INTO THE PULLEY AND IN
THE ENGINE CRANKCASE.
Specific tooling
020474Y Driving pulley lock wrench
- Fit the retainer clamp from the rear, so that the
spline is fully engaged.
- Finally fit the tool by manually drawing the nuts
close and making sure that the tool lays horizon-
tally.
- Tighten the driving pulley fixing nut to the pre-
scribed torque.
- Remove the specific tool.
Locking torques (N*m)
Driving pulley nut 160 - 175
Refitting the transmission cover
- Make sure that 2 centring dowels are correctly
inserted in the crankcase.
- Fit the transmission cover with the bearing and fit
the relevant retainers.
- Lock the four M8 retainers.
Locking torques (N*m)
Transmission cover M8 retainers 23 ÷ 26
Engine
ENG - 133