Engine
Flywheel cover
- Remove the three clamps shown in the figure for
an easy removal of the flywheel cover, remove the
cylinder feed coupling and disconnect the return
coupling from the pump cover
NOTE
THE CLAMPS MUST BE REPLACED. TO RE-
MOVE THEM, OPEN OR CUT THEM USING A
SCREWDRIVER.
BE CAREFUL NOT TO DAMAGE THE PLASTIC
UNIONS
Removing the hub cover
- Drain the engine oil by removing the drainage
plug.
- Prepare a suitable container to collect the oil.
- Remove the pre-filter.
- Remove the oil filter using either a strap-type or
a cup-style oil filter wrench.
ENG - 144
SCARABEO 500