SCARABEO 500
- Clean the camshaft by blowing short blasts of
compressed air, especially the groove that holds
the retaining plate.
- Lubricate the 2 bearings.
- Fit the camshaft in the cylinder head with the
cams opposing the rocking levers.
- Remove any LOCTITE left on the screws fixing
the camshaft retaining bracket using a brush.
- Apply the recommended product to the fixing
screws and tighten them to the prescribed torque.
Recommended products
Loctite 243 Medium strength threadlock
-
- Insert the camshaft retaining bracket so that the countersinks are visible and tighten the 3 fixing screws
to the prescribed torque, being careful not to damage the internal hexagon.
Locking torques (N*m)
Camshaft retaining bracket screws 4 ÷ 6
- Fit the intermediate gear with torque limiter and
the flywheel and its cover as described in the «Fly-
wheel and Start-up system» and «Flywheel cover»
Chapters.
NOTE
FOR FACILITATE THE OPERATION, FIT THE
FLYWHEEL COVER WITHOUT THE COOLING
SYSTEM SLEEVES.
- With the TORX wrench, remove the timing check
cap.
Engine
ENG - 191