APRILIA SCARABEO 500 2008 Service Station Manual page 212

Engine
- Insert the crankshaft on the pin and afterwards
into the bushing with great care.
- Before inserting it thoroughly, align the oil pump
gear with the control gear.
- Insert thoroughly and remove the specific tool.
NOTE
UPON INSERTING THE SHAFT ON THE CRANKCASE HALF, BE CAREFUL NOT TO DAMAGE
THE MAIN BEARING WITH THE THREADED TANG OF THE CRANKSHAFT AND WITH THE TIM-
ING CONTROL TOOTHED PINION.
- Install the oil pump housing cover.
- Tighten the 2 flanged fixing screws to the pre-
scribed torque.
Locking torques (N*m)
Oil pump compartment cover bulkhead
screws 8 - 10
Refitting the crankcase halves
- Remove the oil guard from the transmission-side
crankcase half using a screwdriver.
- First lubricate a new oil guard and then fit it using
the specific tool, place it 0.5 mm recessed from the
crankcase plane.
CAUTION
A WRONGLY POSITIONED OIL GUARD AD-
VERSELY AFFECTS THE LUBRICATION OIL
CIRCULATION.
Specific tooling
020360Y 52 x 55 mm adaptor
ENG - 212
SCARABEO 500