Table of Contents
Advertisement
Sewing feet
Fig. 36: Setting an even sewing foot stroke
Performing the setting steps
1. Set the handwheel to the 0° position.
2. Loosen the screw (3).
3. Lower the presser foot (1) and feeding foot (2) together down to the
4. Tighten the screw (3).
13.2 Setting the stroke movement for the feeding foot
For correct feed, the stroke movement for the feeding foot must be aligned
to the stroke movement for the feed-dog.
Order
First check the following settings:
• Feed-dog movement ( 9.2 Setting the feed-dog movement,
• Even sewing foot stroke ( 13.1 Setting an even sewing foot stroke,
Service manual 567 classic - 01.0 - 10/2015
(1) - Presser foot
(2) - Feeding foot
throat plate.
While doing so, make sure that the feeding foot is only lowered down to
the throat plate. Do not inadvertently lower the feeding foot through the
throat plate cut-out down to the feed-dog.
WARNING
Risk of injury.
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch the sewing machine off before you check
and set the stroke movement for the feeding foot.
page 30)
page 46)
(3) - Screw
(4) - Sewing foot lever
47
Advertisement
Table of Contents
