Setting The Eccentric For The Forward And Backward Stitches - Dürkopp Adler 567 CLASSIC Service Manual

4. Remove the stitch length adjusting wheel (1).
5. Remove the setscrew from one of the two mark-off openings (3).
6. Screw the setscrew into the mark-off opening for the required maximum
7. Turn the scale such that the 0 is exactly next to the adjusting mark.
8. Fit the stitch length adjusting wheel (1) and hold it using a key.
9. Tighten the screw (2).
8.1 Setting the eccentric for the forward and backward
Correct setting
The forward and backward stitches are the same length.
As a test, sew a seam forwards, stop, and sew a seam backwards. The
insertions of the forward and backward stitches have to lie within each oth-
er.
Cover
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
Fig. 19: Setting the eccentric for the forward and backward stitches
Setting steps
1. Unscrew the setscrew (2).
2. Turn the eccentric screw (3) from the right through the opening in the
26
stitch length. The openings are given numbers for the stitch length:
stitches
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch off the sewing machine before setting the
eccentric.
page 10)
(1) - Clamp
(2) - Setscrew
base plate:
Setting the stitch length limit
(3) - Eccentric screw
(4) - Recess
Service manual 567 classic - 01.0 - 10/2015