Sewing Foot; Timing The Sewing Foot Movement - Dürkopp Adler 806N-111-10 Service Instructions Manual

4. Watch the thread passage.
5. Loosen the screws (1) (2x).
6. Turn the handwheel until the hook tip is at the 3 o'clock position after
7. Use a hexagon screwdriver (width across flats 2.5 mm) to turn the shaft
8. Tighten the screws (1) (2x).

4.6 Sewing foot

For the adjustment of the lower and upper stroke position of the sewing
foot, refer to  chapter 4.11 of the Operating Instructions.

4.6.1 Timing the sewing foot movement

Fig. 24: Timing the sewing foot movement
(1) - Screws
Proper setting
The sewing foot should start moving upwards when in the foot stroke
position.
46
the loop has been picked up.
(2) until the finger is at the front inversion point, where the capsule is
completely lifted.
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
(2) - Eccentric
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 111
②