Table of Contents
Advertisement
Setting the stitch length adjusting wheel
4. Move the lower toothed belt pulley (3) sufficiently far to the side that the
5. Tighten the setscrews (4).
6. Use the screwdriver to push the toothed belt (1) back again.
7
Correct setting
Stitch length adjusting wheel to 0:
No play on the stitch regulator gear. The plates for the gear are paral-
Cover
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
Setting steps
1. Switch off the machine at the main switch.
Fig. 16: Setting the stitch length adjusting wheel I
2. Hold the stitch length adjusting wheel (1) using a key (6).
3. Loosen the screw (2).
4. Remove the stitch length adjusting wheel (1) from the shaft (4).
Service manual 567 classic - 01.0 - 10/2015
toothed belt (1) makes contact with the retaining ring (2) without being
pushed away.
Setting the stitch length adjusting wheel
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch the sewing machine off before you set the
stitch length adjusting wheel.
lel, the frame cannot be moved.
page 10)
①
②
(1) - Stitch length adjusting wheel
(2) - Screw
(3) - Adjusting mark
(4) - Shaft
(5) - Scale
(6) - Key
⑥
⑤
④
③
23
Advertisement
Table of Contents
