Table of Contents
Advertisement
Correct setting
Stitch length adjusting wheel set to 0.
The feeding foot (1) touches down exactly on the feed-dog (2) when
Fig. 37: Stroke movement for the feeding foot and feed-dog
Cover
• Arm cover ( 3.3.2 Removing and fitting the arm cover, page 11)
Fig. 38: Setting the point in time for when the feeding foot touches down
Setting steps
1. Position the stitch length adjusting wheel to 0.
2. Loosen the setscrews (2).
3. Turn the stroke eccentric (1) such that the feeding foot touches down
4. Tighten the setscrews (2).
48
the downwards movement of the needle tip (3) reaches the upper
edge of the feeding foot. This will occur when the handwheel is in the
95° position.
(1) - Feeding foot
(2) - Feed-dog
①
②
(1) - Stroke eccentric
on the feed-dog when the handwheel is in the 95° position.
In doing so, do not move the stroke eccentric (1) laterally on the axle.
(3) - Needle tip
(2) - Setscrews
Service manual 567 classic - 01.0 - 10/2015
Sewing feet
Advertisement
Table of Contents
