Table of Contents
Advertisement
Setting the feed-dog
4. Move the drive (3) forwards and backwards and observe the feed-dog
5. Turn the pusher eccentric (2) such that the feed-dog and needle no
6. Tighten the setscrews (1).
9.2.2 Setting the feed-dog height in the top dead center
The feed-dog reaches the maximum stroke height at the top dead center
when the position of the handwheel is 190°.
Correct setting
Place the feed-dog in the uppermost position by turning the handwheel.
The upper edge of the feed-dog protrudes 0.5 mm above the throat
Cover
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
Fig. 23: Setting the feed-dog height
Setting steps
1. Put the handwheel into the 190° position.
2. Loosen the setscrews (2) on the lever (1) at the left, above the hook.
3. Turn the lever (1) such that the upper edge of the feed-dog protrudes
4. Tighten the setscrews (2).
Service manual 567 classic - 01.0 - 10/2015
and needle in the process.
longer move when the stitch adjustment lever (3) is pressed.
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch off the sewing machine before checking and
setting the feed-dog height.
plate.
page 10)
1
(1) - Lever
0.5 mm above the throat plate.
(2) - Setscrews
31
Advertisement
Table of Contents
