Setting The Stitch Length Limit - Dürkopp Adler 567 CLASSIC Service Manual

Setting the stitch length limit

8
9 or 6 mm can be selected as the maximum stitch length. In doing so, the
appropriate throat plate has to be selected for the respective maximum
stitch length. The throat plate cut-out must be large enough that the feed-
dog does not hit against the edges of the throat plate at the front and rear
dead center.
If during the sewing operation not all stitch lengths are available, then you
do have the option to limit the maximum stitch length that can be set.
Correct setting
Turn the stitch length adjusting wheel clockwise as far as it will go.
 The stitch length adjusting wheel can only be turned up to the maxi-
Fig. 18: Setting the stitch length limit
①
②
Setting steps
1. Position the stitch length adjusting wheel (1) to 0.
2. Hold the stitch length adjusting wheel (1) using a key.
3. Loosen the screw (2).
Service manual 567 classic - 01.0 - 10/2015
Setting the stitch length limit
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch off the sewing machine before setting the
maximum stitch length limit.
ATTENTION
Risk of damaging the feed-dog due to incorrect throat plate size
If the throat plate cut-out is too small, then the feed-dog can hit against
the edges.
Make sure that an appropriate throat plate is used for the maximum
stitch length set.
mum stitch length set.
(1) - Stitch length adjusting wheel
(2) - Screw
(3) - Mark-off openings
③
25