Table of Contents
Advertisement
19.2.2 Draining the water condensation
Water condensation may accumulate in the water separator of the pres-
sure controller.
Correct setting
Water condensation cannot rise up to the filter element (1).
Check the water level in the water separator on a daily basis.
Fig. 61: Draining the water condensation
Maintenance steps
1. Place the collection tray under the drain screw (3).
2. Unscrew the drain screw (3) completely.
3. Allow water to drain into the collection tray.
4. Tighten the drain screw (3).
72
WARNING
Risk of injury.
Switch off the machine at the main power switch
and disconnect it from the pneumatic network be-
fore you drain the water from the water separator.
ATTENTION
Machine damage due to too much water
Too much water can result in damage to the machine.
Check the water level every day and drain water, if necessary.
6
4
8
2
10
0
1
2
3
(1) - Filter element
(2) - Water separator
(3) - Drain screw
Service manual 567 classic - 01.0 - 10/2015
Maintenance work
Advertisement
Table of Contents
