Aligning the needle bar linkage
Fig. 26: Aligning the needle bar linkage in the sewing direction
Correct setting
Stitch length adjusting wheel to 0.
Needle pierces in the center of the needle hole for the feed-dog.
Setting steps
1. Position the stitch length adjusting wheel to 0.
2. Loosen the setscrews (1).
3. Align the needle in the center of the needle hole for the feed-dog.
4. Tighten the setscrews (1).
Order
Then check the following setting:
• Loop stroke position ( 11.2 Setting the loop stroke position,
Service manual 567 classic - 01.0 - 10/2015
(1) - Setscrews
page 38)
①
35