Table of Contents
Advertisement
Position of the hook and needle
Fig. 27: Setting the hook clearance
1. Machine locked in place at position 1 ( page 16).
2. Loosen the screws (4) for the hook support (3).
3. Loosen the setscrews (2) for the hook clamping ring (1).
4. Move the hook support (3) sideways such that the distance between the
5. Tighten the screws (4) for the hook support (3).
6. Check the loop stroke position ( page 38).
7. Tighten the setscrews (2) for the clamping ring (1).
8. Remove the lock ( page 17).
Order
Then check the following setting:
• Position of the needle guard ( 11.3 Adjusting the needle guard,
Service manual 567 classic - 01.0 - 10/2015
①
②
(1) - Clamping ring
(2) - Setscrews
(3) - Hook support
hook tip (6) and the groove for the needle (5) is 0.1 mm at most, without
the hook tip (6) touching the needle.
page 40)
④
⑤
③
(4) - Screws
(5) - Needle groove
(6) - Hook tip
⑥
37
Advertisement
Table of Contents
