Table of Contents
Advertisement
11.3 Adjusting the needle guard
The needle guard prevents contact between needle and hook tip.
Order
First check the following settings:
• Loop stroke position ( 11.2 Setting the loop stroke position,
• Hook side clearance ( 11.1 Setting the hook side clearance,
• Needle bar height ( 11.4 Setting the needle bar height, page 41)
• A straight and undamaged needle must be inserted
Correct setting
Machine locked in place at position 1 ( page 16).
The needle guard pushes the needle just enough away so that it can-
Cover
• Feed-dog ( 3.3.7 Removing and installing the feed-dog, page 15)
40
WARNING
Risk of injury.
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch off the sewing machine before checking and
adjusting the needle guard.
page 38)
page 36)
( Operating manual section, Inserting and replacing the needle)
ATTENTION
Damage to the machine, needle breakage, or thread damage due to
an incorrect clearance between the needle and hook tip
Check the distance to the hook tip after inserting a new needle with a
different size.
Reset distance if necessary.
not be touched by the hook tip.
Position of the hook and needle
Service manual 567 classic - 01.0 - 10/2015
Advertisement
Table of Contents
