Table of Contents
Advertisement
Working basis
3.3.7 Removing and installing the feed-dog
Fig. 7: Removing and installing the feed-dog
Removing the feed-dog
1. Remove the throat plate ( page 14).
2. Loosen the screws (3).
3. Take the feed-dog (1) off the feed-dog carrier (2).
Installing the feed-dog
1. Place the feed-dog (1) onto the feed-dog carrier (2).
2. Tighten the screws (3).
3. Insert the throat plate ( page 14)
Important: Check the feed-dog position in its movement at maximum
Order
Then check the following setting:
Feed-dog ( 9.1.1 Moving the feed-dog, page 28)
Service manual 567 classic - 01.0 - 10/2015
WARNING
Risk of injury.
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch the sewing machine off before you remove
or install the feed-dog.
(1) - Feed-dog
(2) - Feed-dog carrier
stitch length (depending on the equipment: 6, or 9) by turning
on the handwheel. The feed-dog must have an even distance
from the throat plate. The needle must be positioned in the
center of the needle hole on insertion.
(3) - Screws
15
Advertisement
Table of Contents
