Table of Contents
Advertisement
5. Carefully turn the shaft (4) clockwise using a 10 mm wrench.
Fig. 17: Setting the stitch length adjusting wheel II
⑦
⑧
6. Check whether the frame (7) for the stitch regulator gear can be moved.
7. As soon as the frame (7) no longer moves: Remove the wrench from
8. Turn the scale (5) such that the 0 is exactly next to the adjusting mark (3).
9. Place the stitch length adjusting wheel (1) onto the shaft (4) and tighten
10.Screw down the stitch length adjusting wheel (1) using screw (2).
11.Check whether the plates for the stitch regulator gear (8) are parallel to
24
ATTENTION
Machine damage possible if the shaft is turned too strongly.
If you turn the shaft too far, then parts on the stitch regulator gear could
bend or get stuck.
Turn the shaft carefully and stop as soon as you can feel slight resis-
tance.
⑨
(7) - Frame for the stitch regulator gear
(8) - Plates for the stitch regulator gear
(9) - Hole
Insert the locking peg or a hex key into the opening (9) and try to move
the frame (7) up and down.
the shaft (4).
it with a wrench (6).
one another.
If the plates (8) are not parallel to one another:
12. Remove the tension spring (10).
13. Loosen the screw (11).
14. Manually position the plates (8) so that they are parallel.
15. Tighten the screw (11).
16. Attach the tension spring (10).
Setting the stitch length adjusting wheel
⑩
⑪
(10) - Tension spring
(11) - Screw
Service manual 567 classic - 01.0 - 10/2015
Advertisement
Table of Contents
