Table of Contents
Advertisement
Setting the feed-dog
9.1.2 Moving the feed-dog carrier
The feed-dog carrier is connected to the stitch regulator gear via the
sliding shaft and can be moved on this shaft.
Cover
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
Fig. 21: Moving the feed-dog carrier
Setting steps
1. Position the upper stitch length adjusting wheel to 0.
2. Loosen the connection to the tie rod (1) on both screws, ensuring that
3. Loosen the rear screw (6).
4. Loosen the setscrews for the adjusting rings (2).
5. Move the feed-dog carrier cross-line to the sewing direction such that
6. Push the adjusting rings (2) toward each other as far as they will go.
7. Tighten the setscrews for the adjusting rings (2).
8. Move the feed-dog carrier in the sewing direction such that the feed-
9. Tighten the rear screw (6).
10.Tighten the connection to the tie rod using the screws (1).
Service manual 567 classic - 01.0 - 10/2015
page 10)
(1) - Screws
(2) - Adjusting screws
(3) - Sliding shaft
the adjusting rings are not twisted vertically.
the feed-dog is exactly in the center of the throat plate cut-out.
Make sure that the sliding shaft (3) is tightened by the clamping rings.
dog is exactly in the center of the throat plate cut-out.
In the process, make sure that the feed-dog height has the correct
setting.
( 9.2.2 Setting the feed-dog height in the top dead center, page 31).
(4) - Assembly frame
(4) - Plates
(5) - Screw
29
Advertisement
Table of Contents
