Aligning The Needle Bar Linkage In The Sewing Direction - Dürkopp Adler 567 CLASSIC Service Manual

Setting steps
1. Position the stitch length adjusting wheel to 0.
2. Loosen the adjusting wheel for the sewing foot pressure (1):
3. Undo all 3 setscrews (2).
4. Remove the plugs of the openings (3).
5. Release the setscrews behind the plug/opening (3).
6. Move the needle bar linkage sideways such that the needle pierces
7. Tighten the setscrews behind the plug/opening (3).
8. Insert the plugs in the openings (3).
9. Tighten all 3 setscrews (2).
10.Tighten the adjusting wheel for the sewing foot pressure (1):
Order
Then check the following settings:
• Loop stroke position ( 11.2 Setting the loop stroke position,
• Distance of the hook to the needle ( 11.1 Setting the hook side

10.2 Aligning the needle bar linkage in the sewing direction

Cover
• Valve cover ( 3.3.4 Removing and fitting the valve cover, page 12)
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
34
exactly in the center of the needle hole for the feed-dog.
page 38)
clearance, page 36)
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the position of the needle bar linkage in the
sewing direction.
page 10)
Aligning the needle bar linkage
Service manual 567 classic - 01.0 - 10/2015