15.2 Setting the hook thread guide
The position of the hook thread guide determines how the thread is wound
onto the winder.
Correct setting
The thread is wound on evenly over the entire width of the bobbin.
Cover
Arm cover ( 3.3.2 Removing and fitting the arm cover, page 11)
Fig. 47: Setting the hook thread guide
Setting steps
1. Loosen the screw (1).
2. Move the hook thread guide (2):
3. Tighten the screw (1).
56
①
②
(1) - Screw
• To the front: The thread will be wound on further to the front
• To the rear: The thread will be wound on further to the rear
(2) - Hook thread guide
Service manual 567 classic - 01.0 - 10/2015
Winder